Unfold the paper support flap (1) to prevent the paper from sliding off the face-down output tray.Make sure that it is completely inserted into the machine. Put the paper tray firmly back in the machine.The paper guides touch the sides of the paper so it will feed properly.The side to be printed on must be face down.Over filling the paper tray will cause paper jams. The maximum paper mark is located on the right paper guide and marked with 3 red down arrows. The paper is below the maximum paper mark (1).Make sure the guides are firmly in the slots. While pressing the green paper-guide release lever (1), slide the paper guides to fit the paper size.Extend the tray so that the triangular mark is aligned with the line marked LGL. Press the release button (1) in the bottom of the paper tray and then pull out the back of the paper tray.Pull the paper tray completely out of the machine.To load Legal paper into the paper tray, follow these steps:
Your copies may be cut off if the paper is loaded incorrectly in the Automatic Document Feeder (ADF) or paper tray, or if the paper size setting is not programmed correctly.
